
SECTION 2.0 - HNB-A + HNB-B + HNB-C OVERVIEW
2.1 HNB-A, HNB-B and HNB-C Series Technical Specifications
*
Note: HNB can drive 25V-70V speakers with optional HNB-70V2X
matching impedance transformer (see page 24, section 5.2)
Page 8
Installation and Technical Application Guide
H
NB
TM
D
igital multimedia mixer for Audio, Video and Wireless applications
SonicDevices n 9950 Baldwin Place, El Monte CA 91731 n (T) 626-454-8169 n (F) 626-433-1079 n (W) www.sonicdevices.net
Type
2 Channel Mixer Amplifier
Architecture
Digital Class-D amplifier, Microcontroller
Mains Input Power
100-240VAC, 50-60Hz / Energy Star Rated
Input Power (to HNB
TM
)
24VDC/2.5A regulated switching wall supply, UL1310 Class 2, Energy Star,
FCC, CUL, CE listed (provided).
Output Power (from HNB
TM
)
25W Peak 4Ω per channel 12W RMS continuous 4Ω per channel.
Audio Performance (HNB-A)
Frequency Response: 20Hz - 20kHz ( ± 1.5dB )
THD + N:<1.0% at 1kHz rated output, < 0.1% at 1kHz at 10W 4W
Signal to Noise Ratio: 90dB A-weighted (band pass: 20Hz-20kHz)
Channel Separation: 60dB
Dynamic Range: 100dB
Input Sensitivity & Impedance: Program: 0.775V, 10kW electronically
balanced, with RF filter (ferrite).
Outputs (R + L): 4Ω (optimum) or 8Ω, 25V /70V with optional transformer
model HNB-70V2X.
Output Regulation Controls:
• Less than 2dB, no load to full load at 1kHz.
• Master Override (MO) audio level 0-1V POT.
• Master Override (MO) voltage sensitivity 1V-70V POT.
• Master Override (MO) delay (time sec) POT.
• Volume gain POTS on Preamp and Amp.
• Treble and bass POT.
• Power On/Off soft push button.
• Manual ‘Duck’ (1 to -50dB) for Mic input.
Controls-IR Remote (HB-IR, HB-IRRC):
• Volume (+/-, R+L), Mute, Balance (R+L), On/Off
• Redundant manual soft push buttons.
• HB-IRRC provided with (2) AA batteries.
Video Performance (HNB-B): HB-VTx, HB-VRx
• Supports VGA, SVGA, XGA , WXGA computer video to VESA standard.
• Supports NTSC, PAL and SECAM video standards.
• Output transmission via CAT5e meeting ANSI /EIA / TIA 568B standard.
• Operational bandwidth up to 350MHz.
• Horizontal frequency 15-126 kHz.
• Vertical frequency 43-200 Hz.
• Sync signal compatible with TTL level 5V / 3.3V.
• Power at 5VDC nominal from 24VDC/2.5A wall supply (HNB-A).
• Video differential gain / phase at +/- 2%.
• Attenuation loss rated at 6 dB at 1,000 feet at 1MHz typical UTP CAT5e.
• Maximum capacitance at 20 pf / foot UTP.
RF Wireless Receive/ Transmit Performance (HNB-C): HB-Rx, HB-Tx
• (2) RF Receive channels with automatic ‘secure link’ selection.
• RF antenna coverage 40 foot radius / 80 foot diameter nominal X-Y-Z axis.
• RF Frequency hopping modulation in 2.4GHz and 2.5GHz ISM band.
• 802.11 WiFi interference protection.
• GSM / CDMA cell phone interference immune.
• RF data transmit speed up to 2Mps with audio latency delay <2msec.
• Signal-to-Noise >55dB.
• Sensitivity >80dBm.
• Audio Frequency 200Hz to 8KHz @ 16k sample rate 16 bit resolution.
• Audio Distortion THD <1% at 1KHz.
• Mono or Stereo operation with HNB-A (HB-RU receivers/headphones).
• Visual status LED’s (Blue / Red).
• Soft push button channel On / Off.
(continued in next column)
• IrDA secure pairing to Headset, Microphone, Headphone in < 10 seconds.
• Manual front switch option (HB-Tx) for 2nd language translation (Channel 2).
• FCC Part 15 Class B.
• Rechargeable batteries are Lithium Ion Polymer and NiMH capable of 1000+ charges,
100% Fast recharge in (90) minutes typical, 50% charge in (30) minutes.
• Battery chargers with 6v wall power supply are UL / Energy Star rated.
Power Efficiency
<80% at 25W 4Ω, <85% @ 8Ω, <90% at 10W 4Ω, <95% @ 8Ω
Power Consumption
32W / 9.5 btu @ 120VAC, 130ma nominal in ‘Sleep’ mode.
Operating Temperature
-10° to 40°C, 14 to 104°F
Storage Temperature
-20° to 65°C, -4 to 149°F
Input Connections
(3) Stereo/Mono inputs: 3-pin dockable, RCA and 3.5mm jack.
(1) 3-pin dockable Mic or Audio line level (Stereo/Mono).
(1) 2-pin dockable EAO-1 Emergency Audio Off override closure (no polarity).
(1) 2-pin dockable MO override input (+/-).
(1) HD-15 VGA/RGB (HB-VTx).
(1) 4-pin Mini DIN S-video (HB-VTx).
(1) RCA Composite video (HB-VTx).
Output Connections
(2) 2-pin dockable Speaker (R+L).
(1) 3-pin dockable Audio line out (1V/600 Ohm).
(1) RJ45 video out (HB-VTx) and video input (HB-VRx).
(3) RJ45 Audio/Power input and output between HNB-A + B.
(1) IR LED remote 3.5mm jack (HB-IR).
(1) Headphone 3.5mm jack (HB-IR).
(1) HD-15 VGA/RGB, (1) Mini DIN S-video, (1) RCA C-video all with 12”+
cables (HB-VRx).
(1) HD-15 VGA buffered Monitor (HB-VTx).
Internal Connections
(2) 2x6 socket connectors (HNB-A, B, C backplane).
(2) 3-pin header/jumper option (HNB-A backplane).
Visual Indicators
• Front LED video source active (green).
• Power LED for all plug-in modules (green).
• Internal LED for MO active (amber).
• Internal LEDs for power to each channel (green).
• Video signal present LEDs: VGA, S and C video (green).
• 4-character, 7-segment LED display for system setup and control.
• IrDA pairing LEDs (Blue / Red)
• RF Wireless battery chargers with status LED indication of charging / full charge condition
Material and Finish
18 AWG CRS steel / .047” nom. with zinc undercoat and white powder
coat paint or CAD plate.
Dimensions: HNB-A, B, C units internal to EO box:
Length: 3.23” / 82mm, Width: 3.37” / 85.5mm, Height: 2.54” / 64.4mm
Dimensions: HNB-A, B carton:
Length: 5.5” / 139.7mm, Width: 7.5” / 190.5mm, Height: 4.6” / 116.8mm
Dimensions: HNB-C, C1 carton:
Length: 11.25” / 285.75mm, Width: 12.0” / 304.8mm, Height: 4.6” / 116.8mm
Weight:
HNB-A, HNB-B: Product:1.75 lbs., Shipping: 2.25 lbs.
HNB-C (C1, C2, C3): Product: 2.0 lbs., Shipping: 2.5 lbs.
Sansonic HNB A+B+C installmaULb:Sansonic HNB A+B+C installmaULb 6/29/11 6:39 PM Page 8
Comentários a estes Manuais